Interested to Buy Any Domain ? << Click Here >> for more details...
You can ping servers on the subnet your workstation is on,
but not other subnets. What is wrong?
- 7 Answers
- 12110 Views
- Primaccess, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / vishwanath
U need to make the route entry for other subnets in
server's routing table
| Is This Answer Correct ? | 9 Yes | 1 No |
Answer / surya
Obviously you can ping inside your subnet because you are
on the same LAN,but if you want to ping the host which is
out of your Subnet you should MAP the Subnet range in
Routing table.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / pradeep kumar
The question it self stating that if we will ping from other
subnet.
How can a packet will route to other subnet.
Packet doesnt know other than the same subnetwork unless
until its routed and Nated further.
So obviously its unable to communicate to other subnet.
Regards,
Pradeep.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / basha phatan
After u change the ip addres u have to add the requied file
ie /etc/host , /etc/netmaks, /etc/defaultrouter
and if u are in solaris 10 /etc/inet/ipnodes have to modify
and IMPORTANT THAT U HAVE BRING IN VLAN then only from out
side u can ping and connect
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / mahipal
There is no entry of Host address and PTR record found in
DNS.
| Is This Answer Correct ? | 1 Yes | 1 No |
TI RPC stands for ?
2 command you can use to see which directories have been shared out by server machine1?
Your class C network has been subnet-ed. Mask for the new subnets is 255.255.255.224. How many subnets and how many nodes per subnet can you have ?
What routing problems have you troubleshot?
In what protocol, connection must be established before exchanging data. This is a reliable and requires more processing.
how can i restore my BIOS ?
You try "ping server1" and you get "unknown host server1" . Why ?
How do you check the listening ports on a windows box? Command line.
how to check CPU load for system and how to find the problem and how to rectify it??
What is the command to start a service in Windows from command line?
what is uplink?
Which layer deals with i) file system transfer ii) ii) virtual terminals emulation iii) interprocess communication. a. Application b. Presentation c. Session d. Transport
Networking Protocols 
