A device is configured for automatic TEI. What is its address immediately after being switched on - before it starts communicating with the network?
Answer / silpa
At this point, the device has no address - it will make a request to the network and the address will be dynamically allocated.
| Is This Answer Correct ? | 0 Yes | 0 No |
What the B and D channels do?
Why use ISDN?
What is the maximum number of simultaneous connections supported by a Basic Rate Interface?
How ISDN and analogue networks interact?
How can I get more information?
What must each SETUP message contain?
Where does this conversion normally take place?
What protocols are used?
Does the network provider supply the NT1 in North America?
What is the call termination message called?
How to Establish the Link Layer?
When multiple users on an ISPBX are making calls, how many users does the public ISDN network see?