Answer / guest

Answer: C

Answer / ch. siva kumar

Address Resolution Protocol

How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three

1 Answers  

---

UDP works at which layer of the DOD model? A.) Internet B.) Host-to-Host C.) Transport D.) Data Link

2 Answers  

---

Which command enables directly connected network 199.55.72.0 to be used by RIP? A. Router(config router)# rip 199.55.0.0 B. Router(config router)# rip 199.55.72.0 C. Router(config router)# network 199.55.0.0 D. Router(config router)# network 199.55.72.0

1 Answers  

---

Can you explain encapsulating, carrier and passenger protocol?

0 Answers   CCIE,

---

which term use to allow user to conect the remote n/w with ppp dail up conection ras sap sonet mane answer rsa

1 Answers  

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers  

---

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

3 Answers   Cisco,

---

What's the default CDP holdtime in seconds for Cisco routers? A.) 30 seconds B.) 180 seconds C.) 90 seconds D.) 60 seconds

4 Answers  

---

Identify the 2 characteristics regarding MAC addresses? A.) Contains a network portion and host portion B.) Always assigned by System Administrator C.) 48 bits long D.) Contains a vendor code and serial number

1 Answers  

---

Which is the protocol using multiple tcp/ip connections? SLIP or PPP

2 Answers   Sutherland,

---

Explain what is the default behavior of access-list?

0 Answers  

---

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---