Answer / guest

Answer: D

what is diffrence between circit switching and packet switching

1 Answers   HCL, Volvo,

---

What is HSRP and what is difference between HSRP and GLBP

2 Answers   Infosys,

---

Identify the command to disable CDP on an interface? A.) Router(config-if)# no cdp enable B.) Router(config-if)# no cdp run C.) Router# no cdp enable D.) Router(config-if)# no cdp

1 Answers  

---

Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0

1 Answers  

---

Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102

2 Answers  

---

Identify the command that will display the RIP routes entering and leaving the router? A.) Router(config)# debug ip rip B.) Route# debug ip rip C.) Router>debug ip rip D.) Router# debug rip routes

1 Answers  

---

Identify the 2 commands that display the clock rate configured on the serial0 interface? A.) show serial0 B.) show interface serial0 C.) show clock rate serial 0 D.) show controllers serial 0 E.) show running-config

5 Answers  

---

which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?

0 Answers  

---

The following is partial output from a routing table, identify the 2 numbers in the square brackets; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' A.) 100 = metric, 1300 = administrative distance B.) 100 = administrative distance, 1300 = hop count C.) 100 = administrative distance, 1300 = metric D.) 100 = hop count, 1300 = metric

1 Answers  

---

What is an administrative distance of 0 mean? A.) 0 means unbelievable B.) 0 is for EIGRP C.) 0 is the default distance for directly connected networks D.) 0 means unreachable

2 Answers  

---

In port based access-list which command you give instead of ip?

0 Answers  

---

Which layer is responsible for identifying and establishing the availability of the intended communication partner? A.) Application B.) Presentation C.) Transport D.) Session E.) Network

1 Answers  

---