Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the 2 characteristics regarding MAC addresses?
A.) Contains a network portion and host portion
B.) Always assigned by System Administrator
C.) 48 bits long
D.) Contains a vendor code and serial number
- 2 Answers
- 7501 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: C D
MAC addresses are assigned by the vendor. Each MAC address
is 48 bits
long and made up of 24 bits vendor code and 24 bits serial
number.
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / kapilasdhir
C.) 48 bits long
D.) Contains a vendor code and serial number
| Is This Answer Correct ? | 2 Yes | 1 No |
Which ipsec rule is used for the olympia branch and what does it define? (Choose two)
Identify the command that configures the bandwidth to 56K? A.) Router(config-if)# bandwidth 56000 B.) Router(config-if)# bandwidth 56k C.) Router(config)# bandwidth 56 D.) Router(config-if)# bandwidth 56
What is the result of using a hierarchical addressing framework? A. increased availability of addresses B. decreased distance between routers C. increased router memory requirements D. no need to maintain routing information
Identify the 3 guidelines for routers in the same autonomous system? A.) Must be configured for IGRP or RIP B.) Interconnected C.) Assigned the same autonomous system number D.) Configured for the same routing protocol E.) Must be same model of router
Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)
Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port
Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP
What is Spanning Tree Protocol and how it work? I know it is - STP is Spanning tree Protocol. It Stops the looping in the network? How STP work? How it stop Looping in network?
What is the simplest way to remotely configure a router?
Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance
Which cable we connect in db-9?
hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku
CCNA 
