Answer / guest

Answer:: A

A default route is analogous to a default

gateway. It is used to reduce the length of routing tables

and to provide complete routing capabilities when a router

might not know the routes to all other networks.

What command displays detail information about the OSPF interfaces, including the authentication method?

1 Answers  

---

What is the link state routing protocol in the TCP/IP protocol stack? A. IP B. IS-IS C. NLSP D. OSPF E. RIP version 2

2 Answers   HCL,

---

What is 10base5 ethernet lans?

0 Answers  

---

How many fillers we can put in one ip of ipv6?

0 Answers  

---

What is the different between console port and auxiliary port?

0 Answers  

---

how will configure Nat

6 Answers   Spanco,

---

What type of switching creates variable latency through the switch? A.) Cut-Through B.) Inverted C.) Layer 4 D.) Multiplexed E.) Store and Forward

1 Answers  

---

Hi, All I am configuring EIGRP in Packet tracer, after configuring all the things it is not working but in one condition it is working fine if i am putting all my router and network withing one network subnets e.g. 172.16.0.0 or 10.0.0.0 but whenever i am puting different network subnets e.g. in one network it is RA(config-if)#=ip address 10.0.0.1, and in fa0/0= 192.168.1.10 and in RB(config-if)#10.0.0.2 (s1/0) and in S1/1 11.0.0.1 and in fa 0/0 192.168.100.1 ,where as in third router RC(config-if)#=ip address 11.0.0.2 and in fa 0/0 172.16.1.10 and after configuring all this serial is showing up and protocol showing up but eigrp process not taking place after adding eigrp configuration, i tried with "no auto-summary" command but not working.. Suggest me where i missing something? can mail me at : gtech.innovator@gmail.com

20 Answers  

---

In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay

2 Answers  

---

A default route is analogous to a _________. A. default gateway B. static route C. dynamic route D. one-way route

1 Answers  

---

Identify the prompt displayed if in privileged exec mode? A.) Router(config)# B.) Router# C.) Router> D.) Router(priv)#

2 Answers  

---

What is the difference between rip and igrp?

0 Answers  

---