Interested to Buy Any Domain ? << Click Here >> for more details...
How do you use a routing table and for what?
- 2 Answers
- 7008 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / dhaval
For What...
to see running protocol, network that is reachable and
mask, next hope ip address to reach certain network, exist
interface.
how..
type show ip route command in cisco router to see all
available network that router can reach.
| Is This Answer Correct ? | 10 Yes | 1 No |
Answer / rajes
you can use
which protocols it configured wether
rip1
rip2
ospf
eigrp etc
| Is This Answer Correct ? | 3 Yes | 1 No |
Scenario: “In a switch two hosts are connected to port number 1 and 2 respectively; both the ports are configured with same VLAN id. When data is sent from one host to another, in switch VLAN tagging will happen or not? Why?”
How many wires does an RJ-45 cable have ?
In PPP, a protocol frame is used for selecting and configuring the network layer protocol ?
What do you use to monitor TCP/IP stats since the last reboot?
What does a secondary dhcp server do when the primary server is unable to respond ?
Which protocol is working behind DHCP server? and what excatly DORA does?
Which protocol encapsulates IP datagrams on a serial line ?
What is looping and how switching loops are avoided at L2 level?
User Datagram Protocol (UDP) is __ and __ a. connectionless, stateless b. connection-orineted, stateless c. connection-oriented, stateful d. connectionless, stateful
Which is the RIP daemon in Solaris ?
Suppose a Router contain one First Ethernet port(F0/0) and two serial port(i.e S1/0,S1/1) and we want to assign IP address of Class A to all the ports. Let the IP address for F0/0 is 10.1.1.2 and 10.2.1.4 for S1/0 and 10.4.1.6 for S1/1, is it correct ? after that can we configure the router using the routring Protocol 'IGRP ' ?
how can you configure router
Networking Protocols 
