we are operation 3 generator with module 5510 and electronic control module . two generator running system healthy and generator called another one generator running always generator called did not showing system healthy1023
what course we have to do for e&tc1 2179
1.Explain 3D radar. 2.Method of mobile signal jamming. 3.Frequency hopping spread spectrum. 4.How does op-amp works in common mode? 5.Which flip flop is known as universal flip flop and why?
In a 2 stage RC coupled amplifier, the emitter resistance of 1st stage consists of 2 resistances (Re and Re')in series and the bypass capacitor is connected across only one of them(bigger resistance). Why?1948
What's the difference between looping 0s and 1s in K map?
How will you send and receive data to a micro-processor? (One method is I/O mapped I/O which is the other one?)
what is mean by GT?what is the purpose og GT?what is uses of GT?2 3407
why digital signals are preferred over analog in com?7 18825
Router Packet Flow from one network to other network?2 5191
simplification of Boolean Expression- A+A'B.
What is the function of BB2F card?
Define what happens to the conductivity of semiconductor with the rise in temperature? Compare with the conductivity of metals.
what are software interrupts present in 8051 Microcontroller? Only Software interrupts//////
Explain Power Control.
Explain the difference between latches and flip flop?
Explain the difference between leds and pn junction diode?
how does a soft starter works
Define what is zener voltage?
Explain the use of excess-3 code.
what is different between parametrization and data driven testing
Explain the different modes of buck boost converter
Suppose you have been asked to design one electronic circuit then starting from basic what procedure do you follow?It should include all standard industrial measures. Please reply.Thanks.
What is a resistor?
What will happen if we change the polarity of microwave antenna?