Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

Company Name Starts with ...
#  A  B  C  D  E   F  G  H  I  J   K  L  M  N  O   P  Q  R  S  T   U  V  W  X  Y  Z

Aspire MFC Interview Questions

what is message loop how mfc does it internally?

25841

If we write any code for DataGrid methods, what is the access specifier used for that methods in the code behind file and why?

1675

Apply for TDS certificate in bank for rent purpose is wrongly entry as 94C instead of 94I. Is any problem?

960

Special thing in designing a overhead reservoir ? which is different from an ordinary design

449

What are the Formatting and Printing Strings available in PHP?

378

Define recycling of application pool?

291

What are the features of Fully-Distributed mode?

124

What is data control techniques?

311

Why do we need mapping?

58

What is Incremental Crawl and Continuous Crawl?

297

I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?

1091

What is the meaning of Debt reconciliation and how to do debt reconciliation?

1520

What is the structure of a feature?

366

1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

1246

What is a bo repository?

388

What is the procedure to take modvat and its form number

1824