What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 24048 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / ramesh
It is called as current transformer which is used to
transform higher range of current to lower range. It's
output is used as an input to protection circuit and
mearsuring instruments as the protection circuit and
measuring instruments are designed for lower range of
currents. The secondary of current transformer shall be
connected in such a way that it should be get open under
any circumstances. In case the secondary circuit opens,
then the CT gets blasted due to break down of insulation as
very high voltage gets induced in the secondary.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
How to test lightning Arrester?
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
What is the power requirement of tamil nadu for one month?
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
What are the factors influence the choice of an electrc drive?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
Give some differences between open loop and closed loop control systems.
What are the advantages of vscf wind electrical system?
what is servo motor and how to work it.
Do inductive loads have distorted current waveforms ?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
why power factor is important?
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
should %impedance be high or low in a power transformer? if so why?
