What is the difference between Earthing and Neutral?
- 13 Answers
- 23563 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinayak khorate
EARTHING IS MENT TO PASS THE LEAKAGE CURRENT FROM ANY BODY
OF EQUIPMENT AND NEUTRAL IS MENT FOR TO COMPLETE THE
CIRCUIT WITH RESPECT TO PHASE.NEUTRAL IS TAKEN FROM
TRANSFORMER WHILE THE EARTHING IS BUILT IN THE PREMISES ONLY
| Is This Answer Correct ? | 53 Yes | 4 No |
Post New Answer View All Answers
grr resistance & contrator malt continuous
How to set a Zone 1 distance relay for distribution feeder?
How the over load setting for HT Motors calculated-provided in Numerical Relay
What magnetic circuit is formed in berry-type constructions and why?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
I'm generating a pulse of 3V with frequency 80Hz (12.5ms time period) and pulse duration 0.125ms and feeding it to a transformer since i want the pulse to get amplified around 60V. At the output amplification s happening but the pulse is changed to a spike, can you tell me what could be the reason? (an ordinary transformer 220V-12V stepdown transformer is reverse connected ie. now it is 12V-220V stepup and voltage amplification happens)
Where voltage are high and current to be interrupted is low the breaker preferred is:
any earth foult trip the relay but in welding time not trip by earth foult
how we can calculate chiller required ampear?
What is an order of a system.
Can you explain about TEE protection scheme?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What is the efficiency during maximum power transfer?
The synchronous machine excitation system explain
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
