can induction motor run over the rated speed ?
- 12 Answers
- 14956 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / sachin_pawaskar2001
Yes. Either by reducing pole or increasing supply frequency.
| Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
Which type of questions well asked. ?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
difference between the applicability of nortons and thevenin theorem
What is the ideal position cooling fan inside the dc motor?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
When we giving the 3 phase supply to ups system how to coming netural?
if flux and load static in dc motor and supply voltage increases 20% then what happened in speed
What's the difference between non break power supply and non break non short break power supply
Why squirrel cage motor can only use with low starting loads ?
What is the application of Dyn1 and Dyn11 vector group of transformer?
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
