For asynchronous transmission, is it necessary to supply
some synchronizing pulses additionally or to supply or to
supply start and stop bit?
- 2 Answers
- 11090 Views
- IBM, Wipro, I also Faced
- E-Mail Answers
Answer Posted / nithyalakshmi
asynchronous transmission does not required any
syncronizing pulses , instead it needs start and stop bit
to acknowledge the first and last bit of the data which is
transmitted.these bits can be high or low.
In some advanced controllers which has in built UART ,
provide option to select no. of start and stop bits in the
transmission.
| Is This Answer Correct ? | 30 Yes | 1 No |
Post New Answer View All Answers
What is the ratio of majority and minority carriers in intrinsic and extrinsic semiconductors?
What is the difference allen bradley and siemens plc
Why are the coupling capacitors required?
Draw the block diagram of a 128 line EPABX and explain its operation?
What is meant by impedance diagram?
What is meant by the temperature coefficient?
what is signal integrity and what is the use ?
write a program that changes 74H to 47H in 8085 assembly programming
what is the configuration of 1+1+1?
compare the delay in sending x-bit msg over k-hop path in ckt switched nw nin lightil loaded packet swithed nw. the ckt setup time is s per hop,the packet size is p bits n data rate is' b' bps under what condition does packet nw have lower delay?
What is scope in rfid?
How can leveltrol be installed in steam drum for measuring the level of steam drum
I am a fresher and i have done testing course from orbit institute hyd.can any1 say me whether it is necessary to do project in testing.if it is that which is best institute in hyd.can you please inform me if there is any job 4 freshers.thanxs
how profibus transfer data?
Explain difference between dcs & plc & scada?
