Interested to Buy Any Domain ? << Click Here >> for more details...
why heat produced at junction of two different conductor.
what care should be taken to minimize it.
- 11 Answers
- 18694 Views
- Birla, Maihar Cement, I also Faced
- E-Mail Answers
Answer Posted / naveen gupta
Two different metals have two different conductivity, so
the movements of electrons get obstructed during this
transition. Thats why the heat get generated.
Now to minimize it we need to increase the surface area
depending upon their conductivity levels.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the cut-off rate?
What are chief characteristics of state-space method and its techniques ?
how to calculate the distance relay faulty zone?pls explain?
what is the use of expulsition protective gap in 11Kv line.
What is different bewteen low or high impedance busbar protection scheme
What is the formula for calculating no-load current?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
Wind mill
IN dc capacitive reactance is??
Why have to use copper cable for local isolator to motor ?
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
What do you mean by per capita requirement of electrical energy in india
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
