why is the vector group analysis done in transformer tests
Answer Posted / shrinivas
vector group are made to know at what position the secondary
winding of transformer we get star and delta voltages . and
it indicates the type of winding in primary and secondary
which helps in parallel operation of transformer with
different ratings having same vector group .
Is This Answer Correct ? | 41 Yes | 13 No |
Post New Answer View All Answers
How to calculate impedance volt in Transformer?
What is the suitable transmission voltage?
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
how to generator maintenance (A Check, B check,Etc)
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
what is the difference b/w UHVDC and HVDC(LIGHT)?
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
What is the physical significant of power factor?
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
Can clean earth cable be considered as low current cable
what is cathodic protaction?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?