what is the difference between electrical & electronics
Answer Posted / athar
1.electrical basically deals with power and energy
transmission while electronics pertains to study and
development of devices which are based on flow of electrons
through devices
2. electrical pertains to transfer of energy through
electricity while electronics transfers information through
electricity
3.electrical works on low frequency high power while
electronics on high frequency low power.....
Is This Answer Correct ? | 94 Yes | 40 No |
Post New Answer View All Answers
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
Where should the lighting arrestor be placed in distribution lines?
The Q-facr o of a coil given as wL/R. what will be shape of Q versus frequency graph.
List the characteristics of filter?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
Why synchronous motor is used in power factor improvement,dc series in lift
What is effect of over voltage and under voltage on ACB
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
plz tel me syllabus and exam date 4 jr executive engg (electrical)
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
what are the stresses in circuit breakers ?
can any tell me why slope 40% and 80% is calculated in differential protection?