How is SmartPlant Instrumentation related to INtools?
- 4 Answers
- 24490 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / sagar tinkhede
Smartplant Instrumentation is the advance version of the
INtools. Till V6.0 it was called as INtools and when
Intergraph upgraded and launched the same to the 7.0 they
named, it as Smartplant Instrumentation i.e, after V7.0
INtools is known as Smartplant Instrumentation and the
latest version for the same is SPI2007 which the widely
used in any engineering organization.
| Is This Answer Correct ? | 23 Yes | 7 No |
Post New Answer View All Answers
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
Manipulation of dead wt. tester double piston type.
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
How to interfacing microcontroller with a DC motor
field bus transmitter calibration procedure tell me
What are different types of valves?
In turbine, what does term CDP, NI, NH, HSSOC, means
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
what diffrence b/w plc s7200,300,400
If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?
How to measure the dust in chimney(spm)?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
