Answer Posted / ytd
It is a device which converts one form of energy or
measures into another form. For eg. Pressure to current,
Vibrations to voltage
| Is This Answer Correct ? | 19 Yes | 0 No |
Post New Answer View All Answers
Explain the key components of control loop?
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
What is three element drum level control system why its better than single element?
which type of zones used for boiler? & why ?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
Why trim span ? How?
Question on maha cement
how to calculate the total flow in square root
can we create an interrupt in plc through scada?
In apron feeder how TPH is calculated?
principle of dead weight tester ?
