what is the use of choke on tube light fitting
Answer Posted / suchak nimish
It is used to provide high voltage approximately 1000 to
1500 Volt.
Is This Answer Correct ? | 44 Yes | 18 No |
Post New Answer View All Answers
how to calculation increase capacitor,increase power factor for three phase.
Where burned of electricity,when,who, & why.
Why to keep capacitor bank off while generator running.
Explain mechanical rotational system?
Under wat condition statcom operates as an inductor for the transmission line?
What does a Bode plot tell you?
What are the advantages and disadvantages of negative feed back?
What is nyquist contour?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
What is phase cross over frequency?
At full load wat is the motor p.f And at no load will is the motor p.f?
What is the difference between isolators and electrical circuit breakers?
Y phase plates are used in transmission line??? what is there need???
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
Define peak time.