Which of the following is true?
A. The default is to send debug output to the console screen.
B. To view debug output from a telnet session, the "terminal
monitor" command must be used
C. If the "logging buffered" command is used, the debug
output would be sent to RAM and can be viewed with the "show
log" command
D. If the "no console loggin" command were configured,
output would besent to a telnet session
E. All of the above
F. None of the above
G. A, B, and C.
H. A, C, D, and E.
- 2 Answers
- 3798 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: E
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Explain what is the default behavior of access-list?
What is the icmp protocol?
Why mac address called physical address?
Which reserve port number talent use?
What are the netbios and netbeui?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
1350 Value in which type of access-list?
How can you assign a vlan to a switch port?
Explain the types of communication in ipv4?
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
What is the difference between an igp and an egp?
Your company has been assigned the IP address of 201.222.5.0 and require having 20 subnets. As the company’s network administrator, find the following: a) the subnet mask (2 marks) b) the number of useable subnets (2 marks) c) the subnetwork address for the 4th subnet (2 marks) d) the first usable IP address for the 4th subnet (2 marks) e) the last usable IP address for the 4th subnet (2 marks) f) the broadcast address for the 4th subnet. (2 marks)
When dr communicate with bdr which multicast ip it use?
What command do we give if router ios is stucked?
What is 10base2 ethernet lans?
