Interested to Buy Any Domain ? << Click Here >> for more details...
why is the vector group analysis done in transformer tests
- 28 Answers
- 74913 Views
- K K Rao, Lloyds, Nicco Engineering Services Limited, Qatar Petroleums, I also Faced
- E-Mail Answers
Answer Posted / dinesh kumar
1,Vector group is done on transformer High voltage winding
with respect low voltage winding.
2,To find the phase angle/difference between different
connections in high voltage windings.
3,In three phase winding transformer there are 36 vector
groups.(1u1v1w 2u2v2w)
| Is This Answer Correct ? | 54 Yes | 39 No |
Post New Answer View All Answers
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2
why using transformer and thyristor switch in 3 phase apfc panel
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
What would be the size of wire used for 2 Ton of window A.C?
how braking & making capacity of circuit breaker are calculated?
what is sevice settings for mccb?How can be it setted?
distribution transformer de-rating formula on over limit iron losses
can anyone provide me a amf panel control wiring using ec-2 relay?
what is the transformer turn ratio formula and give some examples?
How to calculate that clean water supply in one Day from 150 KLD STP?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
how withstand of hi-pot test outputs of transformer wire 2.5mm
what is the meaning of neutral displacement ???
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
