Interested to Buy Any Domain ? << Click Here >> for more details...
What is mean CT Saturation? How to calculate?
- 13 Answers
- 113196 Views
- NCC, I also Faced
- E-Mail Answers
Answer Posted / sundar
generally the CT draws load according to its rating,if it
is drawing more then that specified rating then there is
chance for ct saturation.
| Is This Answer Correct ? | 19 Yes | 77 No |
Post New Answer View All Answers
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
How many double suspension hardware fittings are required on a double circuit transmission tower?
Work done in a free expansion process is
TYPE'S OF BREKAR ,WHAT IS TRANSFORMAR & SAFTY. STARTER DOL & STAR DELTA STARTER.
Keywords: Die, Card, Coin, B/N 2 To 12
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what is transistors comprised of?
how you configure motorvision relay (L&T make)from DCS
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
how does directional relay work incase of ac ?
Star Delta Diagram with full description
Why High voltage are generate noise ?
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
