Why Hg means mecuiry used in vaccum mesuring unit?
- 2 Answers
- 5909 Views
- Manhattan, I also Faced
- E-Mail Answers
Answer Posted / j.santosh ramana kumar
due to low surface density
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how we can calculate power factor in single phase & three phase ?thank u
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
Is RTCC panel needs any control supply.
why transformer tank is in rectangular shape what happen when it is in step shape
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
What are the types of excitation system?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
There is any especial requirement for motor to drive through with VFD?
Why the power factor improvement is so important in industrial loads
HOE WE CAN IMPROOVE BY USE OF CAPACITOR
why the neutral point in connnection oscillates?
why moisture formation found in XLPE Armoured cable outer sheath
