why transmission line 11Kv OR 33KV,66Kv not in 10kv 20kv?
- 43 Answers
- 113972 Views
- A2Z Group, Baiji Power Plant Gas, Electrical, HCL, Kirloskar, Mepco, NEPC, OAMC, UNI, University of Lahore, I also Faced
- E-Mail Answers
Answer Posted / j.santosh ramana kumar
due to thhe form factor=1.11, so output voltage must be
mulipy of formfactor,so we get 11,22,33
| Is This Answer Correct ? | 247 Yes | 44 No |
Post New Answer View All Answers
What is class ab operation?
checking procedure of capacitor based motors.used in fans etc?
in basic 2 phase will short means tripping the power but spot welding 2 phase shorting but not tripping it will welded why.....(Q)
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
How to reduce the static electricity producing in solvent room? By P.D.Patil BioCon
How to maintain ac plant?
HOW TO DESIGN THE body EARTH cable(Copper Conductor) size for 60KVA UPS?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
Define ohm’s law for a.c (alternating current)?
In CTs tan delta point should be earthed , what is the reason behind it?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
What does the a,b,c of 95a,95b,95c relays denotes?
Generator,motor and alternator Working principal Please explain easily
