Which layer is responsible for framing?
A.) Application
B.) Data Link
C.) Physical
D.) Network
E.) Transport
- 2 Answers
- 5147 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is Bandwidth capping
How we can see mac address from dos prompt?
Explain isakmp ?
Suppose we are having two Switches i.e. Switch1 & Switch2 Port1 of Switch1 is Connected to Uplink and switch2 is also connected to switch1? So 1>Is there is any loop? 2>How we come to know that there is a loop created? 3>If we add Switch3 to switch2 then there is a possibility of loop Creation?
Brielfly explain the conversion steps in data encapsulation
How many types of data?
What is difference between static and dynamic routing?
In port based access-list which command you give instead of ip?
After how long eigrp protocol advertise its routing table?
Define network?
Why do you use ‘service password encryption’?
Explain the difference between tftp and ftp application layer protocols?
Explain how many types of ends in wan?
How do you configure a Cisco router to route IPX?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
