The Cisco Catalyst 5000 switch supports full duplex. How
would you
enable it on the second port of the card in slot 1?
A.) router(config-if)# duplex full
B.) router(config)# duplex full
C.) router(config-if)# set port duplex
D.) router(config)#port duplex = full
E.) router(config-if)# set port 1/2 full
- 1 Answers
- 3582 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: A
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are the possible ways of data transmission in ccna?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
What is collision?
Explain how many ways to access router?
Which type of routing you did in ccna?
In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?
Explain the draw back of ospf protocol?
Which ipsec rule is used for the olympia branch and what does it define? (Choose two)
Mention what is the matric of eigrp protocol?
Which multicast ip eigrp protocol use?
When does network congestion occur?
What are the types of communication in ipv6 ?
How many ports are present in a router?
Explain the difference between collision domain and broadcast domain.
Which mode we can't skip when we come back from interface mode?
