Although Cisco IOS 11.2 and later can auto-detect the LMI
type in
Frame Relay, which command will force the LMI type to q933a?
A.) frame-relay lmi-type q933a
B.) encapsulation frame-relay q933a
C.) don't need to, it is the default
D.) encapsulation q933a
E.) encapsulation frame-relay type=q933a
- 1 Answers
- 4117 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: A
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What are 10base2, 10base5 and 10baset ethernet lans?
Why subnetting is used?
Define autonomous system (as)?
Tell me which multicast ip eigrp protocol use?
what is the difference between a ‘half-duplex’ and a ‘full-duplex’ system?
What are the disadvantages of symmetric algorithms?
What do you understand by ‘protocol’ in networking?
What are the steps of conversion for data encapsulation?
which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?
What is size of ipv4 mac address?
When we use extended access-list?
Hi Jitendera, Wat do u do..?? I mean r u working anywhere???? Basically where r u from??? If u don't hv any problem, u can say..?? Or else mail me mr.shahin07@gmail.com
Why we used Virtual MAC in GLBP
What is the difference between the switch, hub, and router?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
