Which command will display adjacent routers found by the Cisco
Discovery Protocol?
A.) show all
B.) show cdp entry
C.) show ip neighbors
D.) show cdp neighbor detail
E.) show cdp neighbor
F.) show neighbor
- 2 Answers
- 4583 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B D E
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Which type for communication switch do?
Differentiate Logical Topology from Physical Topology
which defined peer ip address an local subnet belong to crete? (Choose two)
Explain the difference between switch & hub?
Explain the difference between half-duplex and full-duplex?
When written
Explain the difference between routing and routed protocols?
What is the function of the Application Layer in networking?
How many maximum paths you can give on latest ios in rip?
On which mode we give debug command?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
What is GRE in PPTP?
What is an autonomous system?
In how many ways you can access router?
