Your Ethernet interface currently has the IP address of
1.1.1.1/24. You would like it to have a second IP address of
2.2.2.2/24.
Which command will do that?
A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0
B.) ip address 2.2.2.2 255.255.255.0 secondary
C.) ip address 2.2.2.2 255.255.255.0
D.) This cannot be done, you can only have 1 IP address per
physical
interface.
E.) ip address 2.2.2.2 /24
- 1 Answers
- 3212 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the mau?
what does PPTP use for encryption and authentication?
What are the different types of the password used in securing a cisco router?
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
What is the different between console port and auxiliary port?
What are the different memories used in a CISCO router?
In port based access-list which command u give instead of ip?
Wild card mask always in odd value or even?
Why is network segmentation a good idea when managing a large network?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Define autonomous system (as)?
What is the frame relay?
What are the protocol data units (pdu) in ccna?
What is the command for change serial cost?
What we called 64 bit mac-address in ipv6?
