What 3 sources can configuration commands be placed into RAM?
A.) HP Openview
B.) Console
C.) Vterminal
D.) TFTP server
E.) NVRAM
- 1 Answers
- 3079 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B D E
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Define the logical link control?
How do areas benefit a link state inter network?
What is difference between flsm and vlsm?
What are the netbios and netbeui?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is point-to-point protocol in ccna?
Define network congestion?
What are the ranges of private ips?
Brielfly explain the conversion steps in data encapsulation
What is the different between console port and auxiliary port?
Which command we use for ping in ipv6?
Which layer called error detection layer?
How do you configure a cisco router for routing ipx?
what are the different symmetric algorithms?
How arp brings mac address for switch?
