why C.T secondary are rated 5A generally?
- 13 Answers
- 42753 Views
- ABC, Bhel, I also Faced
- E-Mail Answers
Answer Posted / mahamuni raja
this is not a standard case the CT secondary shall be 5A.
moreover it depends upon the purpose,for protection
generallly will use 5A and for metering 1A. however while
selecting 5A the voltage drop will occur also didtance
between the metering and the protection relay.
| Is This Answer Correct ? | 7 Yes | 10 No |
Post New Answer View All Answers
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
What is the effect of pi controller on the system performance?
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
How could a garment factory benefit from renewable energy
cc of scorpio?
Can you explain about pole discrepancy scheme
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
What is knee point voltage?
how we can calculate chiller required ampear?
Define branch?
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
State the methods of improving power factor?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
