Which two does 100BaseT use?
A.) CSMA/CD
B.) IEEE 802.5
C.) 802.3u
D.) Switching with 53-byte cells
- 1 Answers
- 3307 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: A C
100BaseT - 100BaseT uses two-pair Category 5 UTP cable with
an RJ45
connector and the same pin out as in 10BaseT. 100BaseT
supports full
duplex operation. 100BaseT is limited to 100 meters distance.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the difference between csma/cd?
I simulate ten routers r1 to r10 straightly. I want I can ping from the loop of r1 to loop of r10, but I want I cant ping r1 and r10 from inside routers.?
Utilizing RIP, what is the limit when it comes to the number of hops?
What is the point-to-point protocol in ccna?
What is the key advantage of using a switches?
What do you understand by ‘protocol’ in networking?
Define the virtual channel?
What is the logical link control?
Mention what is bootp?
How many valid ip will b in /21 in route summarization?
what is the matric of EIGRP protocol?
What is difference between routing and routed protocols?
In port based access-list which command you give instead of ip?
What is mac address size of ipv6?
What are 10base2, 10base5 and 10baset ethernet lans?
