How does the cut-through switching technique work?
A.) By using broadcast address as source addresses
B.) The switch waits only for the header to be received
before it checks
the destination address and starts forwarding the packets
C.) The LAN switch copies the entire frame into its onboard
buffers and
then looks up the destination address in its forwarding, or
switching,
table and determines the outgoing interface
D.) By using a Class I repeater in a collision domain
- 3 Answers
- 7103 Views
- I also Faced
- E-Mail Answers
Answer Posted / cut through
Cut - through works at a simple behavior at such
that, you can use an knife to cut through the obstacles
on the way, then everything will be much easier.
So, next time when you met someone whom you don't like,
remember to perform cut-through to get rid of him/her.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What are the different memories used in a CISCO router?
Hi, Can any one please tell me the experience of their CCNA interview,and please tell me all the questions they asked in the interview. Many Thanks...
What are the different layers of osi model?
Explain the difference between switch & hub?
If line up, but protocol down which layer should be troubleshot?
What is Route Poisoning?
What is the difference between static ip addressing and dynamic ip addressing?
How many types of ends in wan?
Define the igp (interior gateway protocol)?
What are 10base2 ethernet lans?
What is subnetting and why it is use?
What is the difference between half duplex and full duplex?
Which command we give for see routing table?
Explain the draw back of eigrp protocol?
What are the netbios and netbeui?
