Interested to Buy Any Domain ? << Click Here >> for more details...
what r the advantage of selecting micro controller type
tripping of circuit breaker than relay type tripping?
- 5 Answers
- 9249 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / manoj
in micro controller type tripping is depend on fault
current value but in relay it is depend torque produce by
fault current.
| Is This Answer Correct ? | 2 Yes | 7 No |
Post New Answer View All Answers
What are the essential characteristics of signal flow graphs?
What is float cum boost charging system?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
As i want some model question paper in basic computer science and history please send me immediately sir
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
What is different between resistance grounding system and resistance earthing system?
I want d.g.set our company
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
What is the minimum underground tank size capacity considered for firefighting purpose?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
