Answer Posted / manjunath kunigal
Maximum Demand is a Total load end output after losses such
as powerfactor etc.
| Is This Answer Correct ? | 19 Yes | 51 No |
Post New Answer View All Answers
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.
What is the count of hvdc transmission lines in india?
The inventer is a battery, but if lost current at home u will turn on the fan but the is AC and inventer battery is dc . Then how the fan was rotating. What device Or machine in fan converst the Dc power to Ac power
Explain Continuous and Discrete signals?
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
What is the dc grounding system and what is diff between AC/DC grounding system?
What is meant by bus bar protection?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
please send me latest & previous years question papers for IOCL Technical level questions
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
