can u please give the exact ckt explaination of AC Drive
related to industries.
- 6 Answers
- 9377 Views
- I also Faced
- E-Mail Answers
Answer Posted / patrice
It is a three phases speed controller
the variable frequency controller is used in the industry
especially on conveyors systems or rotating machines to
adjust the speed according to the flow of the production
It is a regulation of speed
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Explain why use mmwc unit?
What is difference between differential pressure & delta pressure?
How many are the types of instrument cables in terms of No. of pair.
How to calibration a control valve?
What is 3 element control system
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
What is super thermocoupal?
control panel design guidelines
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Pressure tx shows 1 mbar but we need 1000 mbar at this process condition .. how can we sort it out .
Square root calculation for dp flow transmitter?
if in a level tx height is given, how u calculate the ranges of the tx?
give eg of how I/P is used in control loops
Using your own examples solve a problem involving normal table. (experimental method and analysis)
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
