wht factor are considered to design ACB( air Circuit reaker)
415V
Answer Posted / prashant pate
current rating,duty (indoor/outdoor),protections needed,
control voltage,switching mechanism,cost,Switching arcs etc.
Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
The simple way of finding the leakage quantity and % in compressed air distribution system
Explain how you intend to work under pressure to meet up with deadline target?
what is the usage of microcontroller in the panel board?
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
How to Calculate The sag of OPGW in Transmission Line???
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
Why do you have to use Protecion relay with the function MTB ( Mechanical Trip Button ) for electrical system.
sir, Is their any measuring unit of knoking? please explian?
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
What is formula calculation size cable wire ?
Define pole pitch?
If increased the frequency up to 1000 then what changes shows in voltage?