"sap" is used by the Cisco IOS for which encapsulation
types?
A. Ethernet_802.2
B. Token-Ring
C. FDDI_SNAP
D. Ethernet_802.3
E. FDDI_802.2
Answer Posted / guest
Answer: A,B &E
Novell's IPX and Cisco's IOS name their
protocols differently. Cisco uses sap for Ethernet_802.2,
Token-Ring, and Novell's FDDI_802.2. Cisco uses snap for
Ethernet_SNAP, Token-Ring_SNAP, and FDDI_SNAP. Cisco uses
arpa for Ethernet_II and, finally the default is
Novell-ether for Novell's Ethernet_802.3.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is loop back ip in ipv6?
In which protocol you manually enable route summarization?
Frame relay technology works on which layer of osi model?
Name the command we use for ping in ipv6?
What are the protocol data units (pdu) in ccna?
In IPSec what is SAD, SPD and SA's?
Explain the difference between tftp and ftp application layer protocols?
Name the command we give for see routing table?
What are the steps of conversion for data encapsulation?
What is the difference between hub, switch, and router?
Explain the term 'multicast'.
Explain which layer are called upper layer?
What is the frame relay?
What is difference between static and dynamic routing?
Which way of communication bus topology use?