Interested to Buy Any Domain ? << Click Here >> for more details...
what is reset windup in integral control?
- 6 Answers
- 30916 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / sai
Reset windup is a phenomena in Integral control wherin the
integration crosses 100% if it is not limited.
And it takes time to come back to normal....during this
time the process variable deviates from SP considerably.
Remedy is to limit Integration up to 100%.
| Is This Answer Correct ? | 36 Yes | 2 No |
Post New Answer View All Answers
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
What is furnace draft control?
Explain the burnout feature.
please send me the inteview questions in IOCL
Explain Gas Turbine startup and shutdown sequences
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent
Conversions
Make Heater Process Logic.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is motion balance principle?
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
