Answer Posted /

Is This Answer Correct ?    Yes No




Post New Answer   View All Answers


Please Help Members By Posting Answers For Below Questions

Explain ATM reference model.

2


what is the difference you can make by doing your course in the country of your choice

794


Dear Sir i am working in Infosys pune. I am thinking of doing MBA partime. Could you please list the universities in pune. Which have good Campus placement

788


IS TIME COACHING CENTRE(KUKATPALLY HYDERABAD)A GOOD COACHING CENTRE FOR BANK PO EXAMS?

2584


Please send rrb je mechanical question and answers model

626


What is Histogram-derived thresholds?

166


54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?

674


What is load boxes ?

570


how can u define testing and troubleshooting

697


Describe a time when you worked on a team and there was a disagreement between two people. How did you handle the situation?

170


Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?

866


Which Class insulation is prefered for the sandwich Busducts ? Why?

382


Which material grade is better for low temperature application upto -20 deg C either IS 2062 GR B OR IS 2062 GR C ?

600


In manual testing, I have query regarding data conversion testing. I am working on xml document. How do we write test cases for below input as well as for output Input: 1. software Testing Output: 1.software testing

282


We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?

1084