Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bhuvana
PLC is used instead of Relay circuits
It is reduced wire circuit
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
why we r opening HOT BYPASS valve during startup of a compressor?
what is the usage of QDV & VOLUME BOOSTER
typical loop drawing of a simple feedback control comprising of one transmitter and one control
what is the vital subject for scoring bhel exam&what is the question pattern
How to work temperature gauge?
What is Cavitation in a control valve?
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what is difference between HOT permit and cold permit
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
What is limitation of the ht.of the displacer of a level trol?
How hart protocol can be connected with control valves?
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
what is interface level measurement.who can calibrate interface level measurement transmitter online
send me last 5 years questions asked in rrb chennai, for section engineer
