Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashraf majid
Thyristor convertor type AVR(Automatic Voltage Regulator)
is made of Thyristors(Silicon Controlled Rectifiers,SCRs).
We know that output DC voltage from an SCR will not only
depend upon the r.m.s. value of Input voltage applied, but
also at the angle at which the input AC cycle is fired
(using gate signal). If the firing angle is zero(in a
simple circuit), then maximum DC output voltage will be
obtained.If the firing angle is changed from 0 to 180,then
maximum to minimum voltage is obtained. This property could
be used to build an AVR. The firing angle proportional to
Output voltage could be used to trigger the thyristor,in a
closed loop manner and a nearly constant DC voltage(Average
Value) can be obtained.An invertor circuitory could be
utilised to get a regulated AC supply.
Many other configurations can be build from thyristors to
get a regulated AC supply.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
Why does the Solid state Rectifiers for 3-ph brake motors sometimes have 2 & sometimes 3 output terminals?
What does the letter CTNM in negative phase sequence relay means?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
Why r u using pf panel. what the uses
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
defination of lines
i want to know how to determine that a surge arrester work properly in 11kv system. and how to test a 12kv surge arrester
application s to shunt coil
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
Pl. share your experience about industrial-electronics repair of machine tool.
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
working principles of cf lamp,incandescentlamp and f lamp?
