Answer Posted / fawaz firoz
Tower is mostly the tallest structure in an area. Lightnings tends to strike on the highest point in an area. Therefore, the tower is earthed so that the lightning has a path to discharge or else damaging the tower and other equipments under it.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Whata are the types of Cables?
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
How is the gain affected by the introduction of feedback in a control system.
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
Why does the radius of armature is less than the radius of pole shoe?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
what is smart grid? why we use it? explain in detals bcoz i want give presentatin from it....
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
What is primary and backup protection?
How to assume answer to electrical questions
how to set relay setting? and example calculation...
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
where lt & ht capacitor used
