Interested to Buy Any Domain ? << Click Here >> for more details...
What safety precautions you will adopt to work on Steam service control valve?
- 1 Answers
- 3786 Views
- QAFCO, I also Faced
- E-Mail Answers
Answer Posted / hamid
1-Lockout/Tagout
2-PPE
3-Training and Competence
4-Pressure Release
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
If we increase only P what will be controller action ?
Calibration procedure for electro magnetic flow meter
Why trim span ? How?
plz send me general of ongc
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
which type inter lock use in petrochemical refinery,and oil & gas?
What is furnace draft control?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
How to calculate P,I&D value in PID controller ?
what is the difference between Cv and air consumption? why the customer needs Air consumption details?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
