What is meant by H.R.C fuse?
- 40 Answers
- 182011 Views
- Gas Projects, GSCE, Taj Group, I also Faced
- E-Mail Answers
Answer Posted / ali raza
There are different type of fuses HRC is also
one of the type and it stands for " High Rupting Capacity".
This type of fuses normally used where some delay is
acceptable for protecting the system.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
What is different bewteen low or high impedance busbar protection scheme
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
induction 3 phase motor terminal connection
What is the difference between circuit breaker and isolator
what kind of quetions will ask in BHEL in interview? Plz help me?
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
Basic motor transformer generator
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
What is class ab operation?
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
