what is Wave Trap? And its Function ? Detail? Where it is Used?
- 7 Answers
- 78999 Views
- I also Faced
- E-Mail Answers
Answer Posted / bohemia
<a href=" https://www.electricaltpoint.com/wave-trap-line-trap-working-construction-features-use-in-hv-trasmission-electricaltpoint/ "> Wave traps </a> or <a href=" https://www.electricaltpoint.com/wave-trap-line-trap-working-construction-features-use-in-hv-trasmission-electricaltpoint/ "> line traps </a> are used between the transmission line and power station to avoid carrier power dislocation in the power plant and cross talk with other power line carrier circuits connected to the same power station. They offer high impedance to carrier frequencies but pass 50 cycles power currents easily. They can be resonated at a single carrier frequency with a parallel capacitor. The tuning capacitors are protected against the surge voltages by a spark gap arranged in parallel
It is connected series with <a href=" https://www.electricaltpoint.com/radiant-heating-infrared-heating-and-induction-heating-eee/
"> transmission line </a>. it used for communication purpose. It will block the high frequency signal (communication signal) and allow the low frequency (power).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Did RMU have ct and pt ?
What are differences between Voltage, EMF & Potential difference ?
What are factors to be considered while we selecting the Core Balance Current Transformer for Earth fault protection
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
How much no load current of synchronous motor
i need about 10 years of GATE solved papers in pdf format and even mock tests toooo
What is meant by analogous system?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
what is booster? and how it is connected in a circuit?
What is meant by positive and negative feedback?
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
What are conduct on the testing in cf in ur site?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
