why power factor is lagging and leading(i.e -1to +1)
- 2 Answers
- 1753 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagesh.patwari
Practically Power factor will be always lagging as there will be presence of more Inductive load.
Pf can be leading if load is capacitive in nature.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
why a tester wont shock while testing the power in house
what exactly commisioning work does in electrical site work... LT side?..
how many electricity poles are there and what are the names and their sizes.
What is the voltage gain or transfer function of amplifier?
What is the function of the generator exciter?
How much minimum insulation required between 11kv/3.3kv transformer windings?
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
why only exciting current is shown not primary current in transformer???
What are the basic elements used for modeling mechanical translational system?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
