What is the meaning and full form of FTA and MTA in plumbing material
- 2 Answers
- 66291 Views
- FTA, L&T, MTA, I also Faced
- E-Mail Answers
Answer Posted / dhamodharan
Malethreadadaptor and femalethreadadaptor
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
how to calculate load bearing column
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
What is rate for brick masonry work of 1.0 m3 in cm 1:6?
What is the difference between yeild strength and compressive strength of steel???
What is Refuse Area In High Rise Building ?
What is thumb rule in quantity and cost estimation of a residential building?
what is derating factor in cable? what does it mean if derating factor is high/low in terms of thermal resistivity of soil?
how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches
How to calculate Acctually Brickwork Quantity in Honey Comb Brick in circular Soak Pit
IS code for Rolling Margin of steel
resins are not soluble in water soluble in spirit used in varnish left behind on evoporation of oil
How musch steel i.e. angles, channels,and square pipes are required per square feet for a steel roof of residential two storied building?
What is unit weight of roadway layer.. 1.bitumen 2.sand 3.soil 4.concrete 5. aggregate give me some reference for this answers
what is right & short method of measurement of slab&beam
