Answer Posted / prakruthi
It is the proportion of cement, sand and water which gives the necessary strength , stability and consistency to the structure .
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What do you mean by the word 'shear'?
How does siphoning work?
How good are the Weinerberger Porotherm bricks that are being used in construction in Chennai, India. Its being used in non load bearing walls and has a compressive strength greater that 35 kg/cm^2 and a density of approx.694 - 783 kg/m3.
Consumption of Binding wire for fixing of cover block in vertical surface
WHAT R THE GENERAL TECH QUESTIONS ASKED FOR THE INTERVIEW FOR AN AUTOMOBILE INDUSTRY,SPECIALLY DESIGN DEPT
resins are not soluble in water soluble in spirit used in varnish left behind on evoporation of oil
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
Spider cracks occur in beam bottom due to––
(Project Management Topic) What are the important criteria in the successful realization of the project?
What is the likely strength of a 1:2:4 concrete mix?
What is chemical composion test
What is the software used in civil engineering?
How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?
trapozidal
Explain moment of inertia and its importance.