if one of the phase is failed to 3 phase IM. what will happen?
- 6 Answers
- 7287 Views
- I also Faced
- E-Mail Answers
Answer Posted / jack
It will run for few second after that relay will trip becous High current will flow in two other phases so that's why our motor will not burn.😊😉
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
State norton’s theorem?
What is gross error?
What is A check, B check, C Check & D check for a diesel Generat
If we are given a 10 amp cable type and asked to calculate the number of cores used and the thickness of the cable, how do we do it?? please help...urgent!! i hope the question is clear enough!!
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
if we have 320KVA Genset kindly advice how much load we can put it.
what will happens if one phase is missing for 33/11kv power transfomer and why?
can i use ups power as a raw power for another ups
How could a garment factory benefit from renewable energy
Can u Explain about the electronic trivector meter and the use of data converters in them?
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
